Difference between revisions of "DFIT"

From wiki.pengtools.com
Jump to: navigation, search
(→‎Brief)
(→‎Brief)
Line 2: Line 2:
 
[[File:fracture linear flow.png|thumb|right|300px| Stimulated well drainage]]
 
[[File:fracture linear flow.png|thumb|right|300px| Stimulated well drainage]]
  
−
[[DFIT]] is diagnostic fracture injection test or the fracture calibration injection falloff test offers a way to estimate fluid efficiency, leak off coefficient, formation permeability and pressure before the main hydraulic fracture treatment.
+
[[DFIT]] is diagnostic fracture injection test or the fracture calibration injection falloff test performed to estimate fluid efficiency, leak off coefficient, formation permeability and pressure before the main hydraulic fracture treatment.
  
 
==Math & Physics==
 
==Math & Physics==

Revision as of 13:45, 16 February 2022

Brief

Stimulated well drainage

DFIT is diagnostic fracture injection test or the fracture calibration injection falloff test performed to estimate fluid efficiency, leak off coefficient, formation permeability and pressure before the main hydraulic fracture treatment.

Math & Physics

Steady state flow boundary conditions:

P |_{x=x_e/2} = P |_{x=-x_e/2} = P_i
\frac{dP}{dt} =0\ for \ \forall x

From Darcy's law:

\frac{q}{2}=\frac{kA}{\mu}\ \frac{dP}{dx}
A =y_e*h
dP=\frac{q \mu}{2ky_eh} dx

Integration gives: P-P_{wf}=\frac{q \mu}{2ky_eh} x

Since average pressure is: \bar P = \frac{\int P dx}{\int dx}

\bar P = \frac{ \int \limits_{0}^{x_e/2} \left ( \frac{q \mu}{2ky_eh} x + P_{wf} \right ) dx}{\int dx} = \left. \frac{q \mu}{2ky_eh} \frac{x}{2} \right|_{x=0}^{x=x_e/2} + P_{wf} = \frac{q \mu x_e}{8ky_eh} + P_{wf}
J_D=\frac{q \mu}{2 \pi k h} \frac{1}{( \bar P - P_{wf})} =\frac{q \mu}{2 \pi k h} \frac{8ky_eh}{q \mu x_e} = \frac{4y_e}{\pi x_e}=\frac{4}{\pi}

See also

6/π stimulated well potential
JD
optiFrac
fracDesign
Production Potential

Nomenclature

A = cross-sectional area, cm2
h = thickness, m
J_D = dimensionless productivity index, dimensionless
k = permeability, d
P = pressure, atm
P_i = initial pressure, atm
\bar P = average pressure, atm
q = flow rate, cm3/sec
x = length, m
x_e = drinage area length, m
y_e = drinage area width, m

Greek symbols

\mu =viscosity, cp
Retrieved from "https://wiki.pengtools.com/index.php?title=DFIT&oldid=7263"