Difference between revisions of "3 Phase IPR"
From wiki.pengtools.com
(→For PwfG wf b) |
(→For PwfG wf b) |
||
| Line 18: | Line 18: | ||
===For P<sub>wfG</sub> < P<sub>wf</sub> < P<sub>b</sub>=== | ===For P<sub>wfG</sub> < P<sub>wf</sub> < P<sub>b</sub>=== | ||
For pressures between the bubble point pressure and the flowing bottom-hole pressures: | For pressures between the bubble point pressure and the flowing bottom-hole pressures: | ||
| − | :<math> q_t = | + | :<math> q_t =\frac{-C+\sqrt{C^2-4B^2D}}{2B^2}</math> |
===0 < P<sub>wf</sub> < For P<sub>wfG</sub>=== | ===0 < P<sub>wf</sub> < For P<sub>wfG</sub>=== | ||
Revision as of 08:24, 11 April 2019
Contents
Three-phase Inflow Performance Relationship
3 Phase IPR Curve [1]
3 Phase IPR calculates IPR curve for oil wells producing water.
3 Phase IPR equation was derived by Petrobras based on combination of Vogel's IPR equation for oil flow and constant productivity for water flow [1].
3 Phase IPR curve is determined geometrically from those equations considering the fractional flow of oil and water [1].
Math and Physics
Total flow rate equations:
For Pb < Pwf < Pr
For pressures between reservoir pressure and bubble point pressure:
For PwfG < Pwf < Pb
For pressures between the bubble point pressure and the flowing bottom-hole pressures:
0 < Pwf < For PwfG
IPR calculator software
- PQplot nodal analysis software is used to calculate the IPR curves. PQplot is available online at www.pengtools.com.
- Excel
- other
Nomenclature
= formation volume factor, bbl/stb
= dimensionless productivity index, dimensionless
= permeability times thickness, md*ft
= average reservoir pressure, psia
= average reservoir pseudopressure, psia2/cP
= well flowing pressure, psia
= average well flowing pseudopressure, psia2/cP
= flowing rate, stb/d
= gas rate, MMscfd
= temperature, °R
Greek symbols
= viscosity, cp
