29+ reasons why you can not increase the production
From wiki.pengtools.com
To safe time pick a number (multiple numbers are acceptable)
1) It's all foam and the well is pumped off!!!
2) Can not produce below the bubble point: IPR curve reverses
3) The hole is too deviated and pumps don't work inlined
4) Pulling the chokes will make production decrease
5) Scale will form
6) Water will break through sooner
7) Anaerobic bacteria will grow at the perforations
8) Facility is full
9) Oil bubbles through water at 30 t/d; the physical production limit
10) Sharp decline of base production
11) Will damage the Reservoir
12) Bad Sucker Rods
13) We don't have big pumps
14) Production below the bubble point will foul the ESP with gas
15) Ran out of cable
16) Bigger pump will cause interference with adjacent wells decreasing total production
17)
