Liquid loading

Brief

Liquid loading is a phenomenon when the gas phase does't provide sufficient transport energy to lift the liquids out of the well.

In 1969 Turner et al. published an empirical correlation defining the Liquid loading gas velocity.

Math & Physics

The minimum gas velocity to remove the liquid equation:

$v_g = 1.593\ \sigma^{1/4}\ \frac{({\rho_L-\rho_g})^{1/4}}{\rho_g^{1/2}}$.

Note that original paper uses 20.4 constant which is good if the surface tension units are in 'lbf/ft'. Also 20.4 is calculated by adjusting the theoretical equation constant by 20 percent. For the reference PROSPER uses 2.04. PQplot uses 1.593.

The minimum gas rate to remove the liquid equation:

$q_g = 3.067\ \frac{P\ v_g\ A}{T\ z}$

PQplot workflow

In order to estimate the liquid loading point in PQplot:

1. Critirial velocity is calculated 2. Well heat

Discussion

To avoid the Liquid loading the gas velocity should be above the Liquid loading velocity.

The higher the gas rate the higher the gas velocity.

The lower the wellhead flowing pressure the higher the gas rate.

The bigger the tubing ID the higher the gas rate.

In case when the gas rate is limited by the Reservoir deliverability smaller tubing ID will increase the gas velocity.

Nomenclature

$A$ = flow area, ft^2

$P$ = flowing wellhead pressure, psia

$q_g$ = gas rate, MMscf/d

$\rho_g$ = gas density, lbm/ft3

$\rho_L$ = liquid density, lbm/ft3

$\sigma$ = surface tension, dyne/cm (ref values: 60 - water, 20 - condensate)

$T$ = flowing temperature, °R

$v_g$ = gas velocity, ft/sec

$z$ = gas compressibility factor at flowing P & T, dimensionless