Difference between revisions of "Category: PumpDesign"
From wiki.pengtools.com
(→Main Features) |
(→Typical applications) |
||
| Line 7: | Line 7: | ||
== Typical applications == | == Typical applications == | ||
| − | *Sizing of the ESP | + | *Sizing of the ESP to pump off the well |
| + | *Comparison of the different ESPs performance curves (REDA, Centrilift, GE, Borets, Novomet) | ||
*Calculation of the required number of stages and the frequency | *Calculation of the required number of stages and the frequency | ||
*Calculation of the % of the free gas at the pump intake | *Calculation of the % of the free gas at the pump intake | ||
| − | * | + | *Sizing the Motor required |
| + | *Specifying the cable, drive and electrical transformers required | ||
==Main Features== | ==Main Features== | ||
Revision as of 08:23, 3 May 2018
Contents
Brief
PumpDesign is the ESP design tool.
PumpDesign provides the datasheet for the ESP, Motor, Cable and Drive required to achieve the target well flowing rate or bottomhole pressure.
Typical applications
- Sizing of the ESP to pump off the well
- Comparison of the different ESPs performance curves (REDA, Centrilift, GE, Borets, Novomet)
- Calculation of the required number of stages and the frequency
- Calculation of the % of the free gas at the pump intake
- Sizing the Motor required
- Specifying the cable, drive and electrical transformers required
Main Features
- Turn key ESP design workflow
- Interactive ESP catalog
- Interactive Motors catalog
- Tornado chart
- Optimization and sensitivity analysis.
- Motor, Cable, Drive design
Pages in category "PumpDesign"
The following 3 pages are in this category, out of 3 total.
