Difference between revisions of "Category: PumpDesign"
From wiki.pengtools.com
(→Main Features) |
(→Main Features) |
||
| Line 16: | Line 16: | ||
==Main Features== | ==Main Features== | ||
*Turn key ESP design workflow | *Turn key ESP design workflow | ||
| + | *Tornado chart | ||
| + | *Liquid and mixture IPR chart | ||
*Interactive ESP catalog | *Interactive ESP catalog | ||
| + | *Autoselect option for stages and frequency | ||
*Motors and cables catalog | *Motors and cables catalog | ||
| − | * | + | *Autoselect option for cables and drive |
| − | |||
| − | |||
[[Category:pengtools]] | [[Category:pengtools]] | ||
Revision as of 08:27, 3 May 2018
Contents
Brief
PumpDesign is the ESP design tool.
PumpDesign provides the datasheet for the ESP, Motor, Cable and Drive required to achieve the target well flowing rate or bottomhole pressure.
Typical applications
- Sizing of the ESP to pump off the well
- Comparison of the different ESPs performance curves (REDA, Centrilift, GE, Borets, Novomet)
- Calculation of the required number of stages and the frequency
- Calculation of the % of the free gas at the pump intake
- Sizing the Motor required
- Specifying the cable, drive and electrical transformers required
Main Features
- Turn key ESP design workflow
- Tornado chart
- Liquid and mixture IPR chart
- Interactive ESP catalog
- Autoselect option for stages and frequency
- Motors and cables catalog
- Autoselect option for cables and drive
Pages in category "PumpDesign"
The following 3 pages are in this category, out of 3 total.
