Difference between revisions of "Erosional velocity"
From wiki.pengtools.com
(→Erosion) |
|||
| Line 9: | Line 9: | ||
Erosion is normally expressed as a rate of metal loss, usually mm/year. It usually occurs in turns or protrusions; or with solids content. | Erosion is normally expressed as a rate of metal loss, usually mm/year. It usually occurs in turns or protrusions; or with solids content. | ||
| − | One can relate [[Erosional velocity]] to a metal loss rate. | + | One can relate [[Erosional velocity]] to a metal loss rate (see RP 051). |
== References == | == References == | ||
Revision as of 05:44, 8 November 2018
Erosional velocity
The flow of a gas-liquid multiphase system may cause erosion if velocities are high. This is the description of empirical relationships for estimating whether erosion will occur in a system at a certain velocity used at PQplot.
As a rule of thump, pipe erosion begins when velocity exceeds the value of C/SQRT(ρ) in ft/s, where ρ = gas density (in lb/ft3) and C = empirical constant (in lb/s/ft2) (starting erosional velocity). We used C=100 as API RP 14E (1984) suggested C=100 for continuous and 125 for non continuous service.
Erosion
Erosion is normally expressed as a rate of metal loss, usually mm/year. It usually occurs in turns or protrusions; or with solids content.
One can relate Erosional velocity to a metal loss rate (see RP 051).
References
- Mokhatab S, Poe WA, Speight JG (2006) "Handbook of Natural Gas Transmission and Processing", Section 11.6 - Design Considerations on sales gas pipelines, subsection 11.6.1 - Line Sizing Criteria, Elsevier, 2006.
